Cut a section of the ribbon to a length desired, remembering it does not have to be very long to wrap once or twice around a hook shank. Think of the feathers you use and what length of stem is actually wrapped around the hook, but (just as with feathers) you need some to hold on to to form the wraps.

Cut away one of the seams. Where this cut is made dictates the length of the "hackle" fibres. Depending on the size of ribbon you started with you may be able to cut down the middle and get a "two for one" deal.


How strip the parallel fibres to the seam from the cut ends, (flat nosed tweezers can help here) down to the seam. Pull three or four fibres from the seam (the ones that now form hackle fibres) at one end and you have a tie in point.

Tie in with the hackle fibres pointing toward the hook bend and wrap as normal.
If body palmer hackle is sought, the initial section of ribbon should be longer and if you wish you can cut the section lengthways on a taper so the hackle becomes longer as wraps are made up the body.