Top Side
Bottom Side (sharp working edge)
Dana Reed's industrial size dubbing rake (DIY project)
Moderators: William Anderson, letumgo
-
letumgo
- Site Admin
- Posts: 13346
- Joined: Sat Feb 21, 2009 7:55 pm
- Location: Buffalo, New York
- Contact:
Dana Reed's industrial size dubbing rake (DIY project)
Dana showed me a dubbing rake he made out of an old paint brush handle, and the cutter blade from an empty roll of packing tape.
Top Side
Bottom Side (sharp working edge)
Top Side
Bottom Side (sharp working edge)
Ray (letumgo)----<°))))))><
http://www.flytyingforum.com/index.php? ... er=letumgo
"The world is perfect. Appreciate the details." - Dean
http://www.flytyingforum.com/index.php? ... er=letumgo
"The world is perfect. Appreciate the details." - Dean
-
daringduffer
- Posts: 2195
- Joined: Sun Feb 22, 2009 5:11 am
Re: Dana Reed's industrial size dubbing rake (DIY project)
Clever! I bet it will give him 100 bucks on eBay! Sign it first.
dd
dd
Re: Dana Reed's industrial size dubbing rake (DIY project)
It works like a charm!
Soft and wet - the only way....
Re: Dana Reed's industrial size dubbing rake (DIY project)
A friend used to make them out of pieces of hacksaw blades. Using various TPI (Teeth Per Inch) determined how much guard hair you got in the mix. He just cut a slot in a dowel, glued in the hacksaw blade section and he was done. They worked very well.